EurekaZone Products > EZ-1 WoodWorking Centers > Table Accessories >

EZSMART Raised Top Kit
EZSMART Raised Top Kit


 
PHOTO GALLERY


MSRP $60.00
Price $54.00
Deal of the Day Price: $48.60

Availability:: Usually Ships in 1 to 3 Business Days
Product Code: EZT1100
Qty:

Description
 
There are times when you have to make a cut longer than you can do on your EZ-1 Woodworking Center.
For instance you need to rip long pieces from a full sheet of plywood.
Normally you would have to set up your Multiform Table Top to make the cuts.
This requires more floor space, something that is often limited.

There is a better solution.
This kit will let you convert your EZ-1 Woodworking Center to a Multiform Table Top in just a few minutes.
The kit lets you add vertical pieces of wood to your bench that give support to the work piece, and allow clearance for the Smart Clamps or Repeaters.

The kit can be attached with or without the bridge in place.
The kit contains plastic extrusions that slide into the self aligning slot of the SSME.
Just add 3/4" x 3 1/2" wood to the extrusions to complete the conversion.

There are (6) 24" sections of the extrusion and sufficient screws to mount wood that you provide.
You can use any wood you have on hand. After years of use, if the edge of the wood gets too chewed up from the saw cuts, you just replace it with another piece.

The plastic extrusion fits the self aligning slot of any EZ Smart product, not just the SSME.
The Back-to-Back, Rail, or Super Back-to-Back also have slots and with this extrusion, there are all kinds of other possible uses you can come up with. For instance, a short section with holes drilled in the wood could be mounted in a side SME on the bench to hold small tools to help keep them from getting misplaced. If needed, the extrusion can be easily cut into shorter sections with any saw.
Cutting Panels with the EZSmart Track Saw
Shop Versatility